Profile Drum Roasting:  The profile we use is 12:30/14:30/19:00 @ 264 F.  It is a nice robust roast, right at 2 minutes in the Development phase and a solid 4-5 minutes (just under) Finishing phase to keep any raw astringency in check.  I pushed the end temperature all the way into the mid 260s and suspect it could have taken more.  This is a great beginner bean.

Behmor:  Due to the cold start of the the Behmor, you can just set it on the 1 lb setting with 2.5 lb of cocoa and go.  When you begin getting aromatic notes, somewhere around 4 minutes left (14 minutes elapsed of the 18 minute start) drop the power to P3 (50% power) and continue roasting for about another 6-8 minutes, waiting for the aroma to either decrease or get sharp.  This is all of course if you don't have a thermocouple in the beans (Modifying your Behmor) If you have that you can follow the profiles above.

Oven Roasting:  I've been experimenting a lot recently with a less fussy way to oven roast and I find this procedure works pretty well.  It is moderately predictable, repeatable and although not as dynamic and controllable as a drum roaster, does a good job. You will need an IR thermometer.  Roast 2 lb of beans.  Preheat your over to 350 F.  Place your cocoa beans in a single layer on a baking sheet and into the oven. Stir the beans at 5 minutes and check the temperature.  Continue roasting until the surface temperature reads 205-215 F (it may well vary across the beans).  At that point, turn your oven down 20-25 F above your target EOR, in this case 265 + ~25 = 290 and continue to roast, stirring every 5 minutes until approximately 260 F.  Again, there will be variation but the beauty of this method is having turned the oven down it is difficult to over roast.  If you do find your roast is progressing too fast, adjust accordingly, starting at 325 F and/or changing your target to 265 F.  Overall you may well roast 30-40 minutes.  The important part here is to get good momentum going in a hot oven and then basically coasting to finish.